Nortel Meridian 1 Succession 1000 Description page 170

Page 170 of 532
553-3001-367 Standard 1.00
13 Tighten the fillerplate screws.
Note: Place the label supplied with the display on the outside of the
bottom cover of the telephone. This allows proper identification and
tracking of the option level of the set.
Connecting the Display Module Ribbon Cable
14 If installed, remove and discard the NT2K0013 daughterboard.
15 NTZK models: Make sure that the ribbon cable is folded as shown in
Figure 48.
16 NT2K models: Make sure that the ribbon cable is folded as shown in
Figure 49 on page
17 Make sure the red line on the ribbon cable lines up with the white dot
beside the connector pins (P2 on an NTZK M2008, J3 on an NT2K
M2008, and P4 on an M2616) on the motherboard.
October 2003
172.