Resetting An Annex Configuration - Bay Networks Manager User Manual

Part 4 Control and Status Commands
Resetting an Annex Configuration
You can choose
return to the
Boot
Manager notifies the console and all terminals connected to the
Annexes you selected about the boot.
Once the boot takes place, a warning window appears. This window
lists the Annexes where the boot transmission was successful and,
if necessary, lists Annexes where the boot transmission was
unsuccessful.
If you boot an active Annex, its status in the main
window list changes to
although the Annex is not available while boot
processing takes place, a successful boot does restore
the Annex on your network. You can use
State
You can use the
Reset
configuration without booting. This command lets you reset port and
interface settings, several configuration file options, and name servers.
This section explains the
• Displaying the Reset Window
• Understanding the Reset Window Format
• Resetting an Annex
Chapter 19
to activate the boot or
OK
window. When you choose
NOT REACHABLE
to restore the display.
command to change a specific Annex or port
command in the following sections:
Reset
Annex Manager User Guide
Booting and Resetting Annexes
to
Cancel
, Annex
OK
. In fact,
Verify Annex
19-9