Type Async; Values Enabled Or Disabled; Default Disabled - Bay Networks Manager User Manual

Chapter 22 Annex Parameters
ipx_frame_type
ipx_security
ixany_flow_control
keep_alive_timer
lat_key
Annex Manager User Guide
22-54
defines framing used for IPX packets on the Ethernet interface.
Type
Annex
Values
raw802_3, ethernetII, ccitt802, ccitt802snap
Default
raw802_3
Lists
Annex Only, IPX
controls whether IPX security is enabled on the port.
Type
Async
Values
enabled or disabled
Default
disabled
Lists Async Port, IPX, Security
treats any input character as a start (XON) character if output was suspended by
a stop (XOFF) character.
Type Async
Values enabled or disabled
Default disabled
Lists Async Ports, Flow Control
specifies the number of seconds that can elapse between the transmission of
identification packets during times of network inactivity. This parameter works
only for the LAT protocol. The packets serve only as notices to remote nodes
that the host services are available.
Type Annex
Values 0 to 255 seconds
Default 20 seconds
Lists
Annex Only, LAT
restricts access to LAT-specific Annex commands, parameters, functions, and
the LAT protocol within the Annex. Each Annex requires a unique key value.
You must contact your supplier to obtain a LAT key. After you set the key, your
system administrator must reboot the Annex.
Type
Annex
Values
obtained from your supplier
Default
n/a
Lists
Annex Only, LAT
Part 5 Reference Information