Viewing, Creating, and Executing
S
cript commands allow you to create a set of parameter values, store
them as a script, and apply the parameter values of the script to one or
more Annexes.
A script is a text file. Each line in the file defines an Annex parameter
value. You can use Annex Manager to create a script by capturing the
Annex parameter values, or you can create a script using any standard
text editor. After you store a script in a file, you can use it to configure
a new Annex, to save Annex parameter values for backup, or to apply a
special configuration.
This chapter describes the
•
Viewing Script Contents
•
Creating New Scripts
•
Changing Annex Values Using Scripts
Annex Manager provides predefined scripts that you can use to reset
Annex parameters to their factory default values.
contents of predefined or site-specific scripts.
reset Annex parameters to their factory default values when you use one
of the predefined scripts.
If you want to use site-specific default values for any script, you
should copy the script file and then edit it.
Some scripts contain lines that begin with the comment symbol (#).
If you remove this symbol when you edit the file, the script uses these
parameters.
commands. It includes:
Script
Execute Script
Annex Manager User Guide
Chapter 17
Scripts
displays the
View Script
allows you to
17-1