Defocus Settings - Sony DVS-9000 User Manual

• "Setting the aspect ratio of the wipe crop pattern (Aspect)" (page 47)
• "Replicating the wipe crop pattern (Multi)" (page 48)
• "Rotating the wipe crop pattern (Rotation)" (page 47)
• "Applying modulation to the wipe crop pattern (Modulation)" (page 48)

Defocus Settings

This effect defocuses the entire image.
For an illustrative figure and other information, see "DME Special Effects" in
Chapter 1 (Volume 1).
Applying the Defocus effect
1
2
3
4
52
DME Special Effect Operations
In the DME menu, select VF2 'Video Modify' and HF1 'Defocus/Blur.'
The Defocus/Blur menu appears.
Press [Defocus], turning it on.
The Defocus effect is enabled. You can adjust the defocusing of video and
key signals with the knobs.
Note
On the MVE-8000A, the Defocus and Glow effects cannot be enabled at
the same time. The effect which was turned on most recently is enabled.
In the <Defocus Mode> group, select the signal to which to apply the
defocus effect.
Video/Key: Video signal and key signal
Video: Video signal only
Key: Key signal only
Note
"Key" can be selected only when the MVE-8000A/MVE-9000 is
connected through an SDI interface.
Set the parameters.
• When Video/Key is selected (with DME dedicated interface)
Knob Parameter
1 H
Adjustment
Horizontal defocusing of video
and key signals
Setting values
0.00 to 100.00