Sony DVS-9000 User Manual page 398

Making editor port settings
In the <DME1 Editor Port Setting> group of the DME >Device Interface menu,
press either of the following to select the way in which the editor ports are used.
Common: Control all of channels 1 to 4 through Editor ports 1 to 4.
Independ: Control channels 1 to 4 individually through Editor ports 1 to 4.
Making DME GPI input settings
1
In the DME >Device Interface menu, press [DME1 GPI Input].
The DME1 GPI Input menu appears.
2
Using any of the following methods, select the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob
1
2
3
In the <Trigger Type> group, select the trigger polarity.
pulse.
input signal.
high.
No Operation: Apply no trigger on an input pulse.
4
In the <Target> group, select what this applies to (channels 1 to 4, or Proc).
5
Using any of the following methods, select the action to be set.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Parameter Adjustment
Port Input port selection
No Selection of number for action to
be assigned
(Rising Edge): Apply the trigger on a rising edge of an input pulse.
(Falling Edge): Apply the trigger on a falling edge of an input
(Any Edge): Apply the trigger on a change in the polarity of the
(Level): Carry out the specified operation when the input is low or
Setting values
1 to 8
1 to 8
397
Setup Relating to DME