Settings for the Flexi Pad
You can select the pattern numbers or register names as the button indications
for Flexi Pad control block and the following menus.
• M/E-1 > Wipe >Wipe Snapshot menu
• M/E-1 > DME Wipe >DME Wipe Snapshot menu
• Misc >Snapshot menu
Note
The CCP-9000/9000A system has no Flexi Pad.
1
In the Panel >Operation menu, press [Flexi Pad Mode].
The Flexi Pad Mode menu appears.
The status area shows a list of the items with their settings.
2
Make the following settings as required.
Coupling the transition type selection with the Flexi Pad control block
mode selection: To make the Flexi Pad mode selection change
automatically when [WIPE] or [DME] is selected in the transition
control block, press [Wipe/DME Auto Deleg], turning it on.
Button indications in the memory recall section: When the Flexi Pad
control block mode is [WIPE] or [DME], for the button indications in
the memory recall section, select [Pattern] or [Register Name] in the
<Wipe/DME Display> group. When the mode is [Snapshot], [Effect],
or [MCRO], select [Register No] or [Register Name] in the
<Snapshot/Effect Display> group.
For details, see the following.
• "Wipe Snapshots" in Chapter 5 (Volume 1)
• "DME Wipe Snapshots" in Chapter 6 (Volume 1)
• the figure of the memory recall section in "Recalling the master timeline
in the Flexi Pad control block" (page 185)
• the figure of the memory recall section in "Saving and Recalling
Snapshots"(page 240)
• the figure of the memory recall section in "Recalling a Macro Register
and Executing a Macro"(page 459).
Setting the button operation mode
1
In the Panel >Operation menu, press [Custom Button].
The Custom Button menu appears.
The status area shows a list of the items with their settings.
2
Make the following settings as required.
Setup Relating to Operations From the Control Panel
355