Sony DVS-9000 User Manual page 410

Knob Parameter
1 Port No
a) The setting value range depends on the DCU port setting. (When the MKS-2700 is
connected, select 2 for the slot and a value in the range 1 to 6 for the port.)
3
Using any of the following methods, select the protocol for the connected
device.
• Press directly on the list on the right of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter
2 Device Type
a) 1. No Assign: nothing is connected to the serial port.
2. P-Bus: P-Bus device.
3. VTR: VTR
4. DDR SD9P: disk recorder (Sony disk 9-pin protocol)
5. DDR VDCP: disk recorder (video disk communication protocol)
6. Extended VTR (Abekas A53 protocol)
7. Mixer ESAM-II
Note
Mixer ESAM-II cannot be operated from this system. It can only be
operated from an editing keyboard.
4
Press [Device Type Set].
The selected protocol is reflected on the left of the status area.
5
To enter the name of the serial port, press [Set] in the <Name> group.
A keyboard window appears. You can enter a name of not more than 16
characters.
If no name is set for the serial port, it is displayed as "DCUd_PORTs-p."
d: 1 or 2 (DCU No.)
s: 2 to 6 (Slot No.)
p: 1 to 6 (Port No.)
6
Press [Enter].
To return the set name to the default name
Press [Clear] in the <Name> group.
Adjustment
Serial port
Adjustment
Protocol selection
Setting values
a)
1 and upwards
Setting values
a)
1 to 7
409
Setup Relating to DCU