Sony DVS-9000 User Manual page 473

Executing a macro in normal execution mode (with pause events
set)
When execution of a macro is paused, the [Take] button is assigned to the
memory recall section.
To restart the macro execution, press the [Take] button.
You can switch the normal execution mode and step execution mode in the
Setup menu. See "Setting the macro execution mode" (page 358).
Executing a macro in step execution mode
To recall a macro register and execute the macro in step execution mode, use
the following procedure.
1
472
Macro Operations in the Standard Type Flexi Pad Control Block
• During macro execution, recalling the same register again stops the
macro being executed.
• Individual events stored in a macro are executed according to the
settings in setup. If you change the settings in setup, a saved macro may
not have the expected effect.
• During macro execution, if you switch the control panel to macro editing
mode, the macro being executed stops.
• During macro editing it is not possible to execute a macro.
• If you start execution of a macro by operating the Flexi Pad control block
for an M/E or PGM/PST bank, the numeric keypad control block or a
button for which a macro attachment is set, then before the end of
execution of that macro you cannot recall and execute a separate macro
from the Flexi Pad control block for a different bank.
In the Flexi Pad control block, recall the macro register.
For details of recalling macro registers, see "Recalling a Macro Register
and Executing a Macro" (page 470).
The Flexi Pad control block memory recall section is assigned to the
display of the [Take] button and macro execution status, as in the following
figure.