Sony DVS-9000 User Manual page 403

2
3
4
402
Setup Relating to DCU
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter
1 No
In the <Trigger Type> group, select the trigger polarity.
(Rising Edge): Apply the trigger on a rising edge of an input pulse.
(Falling Edge): Apply the trigger on a falling edge of an input
pulse.
(Any Edge): Apply the trigger on a change in the polarity of the
input signal.
(Level): Carry out the specified operation when the input is low or
high.
No Operation: Apply no trigger on an input pulse.
In the <Target Device> group, select the control panel to handle the GPI
input.
SCU1: ID1 control panel (PNL1)
SCU2: ID2 control panel (PNL2)
SCU3: ID3 control panel (PNL3)
The action set in the following step 4 is executed for the switcher and DME
controlled by the selected control panel.
Using any of the following methods, select the action you want to set.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob Parameter
2 Action
4 Aux Bus No
5 Reg No
5 Src No
a) • Action list when the trigger type is other than "Level"
Adjustment
GPI input
Adjustment
Action selection
Aux bus selection
Register number
Source signal selection
Setting values
1 to 50
Setting values
a)
1 and upwards
e)
1 to 48
b)
1 to 4
c)
1 to 99
d)
1 to 399
e)
1 and upwards