Sony DVS-9000 User Manual page 465

3
Inserting an event
1
2
3
4
5
Modifying a single event
1
2
3
4
Modifying a particular range of events
1
464
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
Using any of the following methods, specify the edit point.
• To move the edit point to the event immediately following the current
macro event, press the [NEXT KF] button in the keyframe control block.
• To move the edit point to the event immediately preceding the current
macro event, press the [PREV KF] button in the keyframe control block.
• To move to an edit point by specifying an event number (the number
showing the position of the event in the macro execution sequence),
press the [GO TO KF] button in the keyframe control block, then in the
numeric keypad control block, enter the target number and confirm with
the [ENTER] button.
Specify the edit point. (See page 463.)
If required, press the [AUTO INS] button in the keyframe control block to
toggle the auto insert mode on or off.
Create the event.
• When auto insert mode (see page 461) is on, the event is automatically
added to the macro.
• When auto insert mode is off, proceed to step 4.
When auto insert mode is off, press the [INS] button in the keyframe
control block.
Repeat steps 3 and 4 to insert the required events in the macro.
Specify the edit point. (See page 463.)
If the [AUTO INS] button is lit, press it to turn off the insert mode.
Create the event.
Press the [MOD] button in the keyframe control block.
Carry out steps 1 to 3 of the procedure in "Modifying a single event" (the
previous item).