Interfacing With External Devices (Device Interface Menu) - Sony DVS-9000 User Manual

Note
This setting is valid when an SDI-interfaced MVE-8000A or an MVE-9000 is
used.
1
2
3
4
5
Interfacing With External Devices (Device Interface
Menu)
To carry out setup relating to DME connections with external devices, display
the DME >Device Interface menu.
To display the Device Interface menu
In the Engineering Setup menu, select VF4 'DME' and HF4 'Device
Interface.'
In the following description, the settings for DME1 are given by way of
example, but the settings for DME2 are carried out in a similar way.
Setting the editor protocol
In the <DME1 Editor Protocol> group of the DME >Device Interface menu,
press the following buttons to make the setting.
DME: Control by DME protocol through the editor port.
VTR: Control by VTR protocol through the editor port.
396
Setup Relating to DME
In the DME >Output menu, press [Monitor Output].
The Monitor Output menu appears.
In the <Select> group, select the DME to which the setting applies.
DME1: Select DME1.
DME2: Select DME2.
In the list on the left of the status area, press directly on the monitor output
for which you want to make setting.
In the list on the right of the status area, press directly on the signal you
want to output.
Press [Set].
The selection is reflected in the monitor output.