Settings Relating To Function Links (Link Menu) - Sony DVS-9000 User Manual

2
Set the following parameter.
Knob
3
Setting the mode in which all signals can be selected for input to
the color corrector
Press [CCR Internal Signal Enable] in the Switcher > Key/Wipe/FM/CCR
menu, turning it on.
You can select signals generated internally to the switcher as material for input
to the color corrector.
Note
When you select an M/E reentry signal as material for input to the color
corrector, 1H delay occurs to the output signal of M/E.

Settings Relating to Function Links (Link Menu)

Carry out setup relating to links by displaying the Switcher >Link menu.
To display the Link menu
In the Engineering Setup menu, select VF3 'Switcher' and HF6 'Link.'
The status area shows the current link information.
Setting a cross-point button link
To link together two buses internal to the switcher, use the following
procedure.
1
In the Switcher >Link menu, press [Internal Bus Link].
The Internal Bus Link menu appears.
The status area shows the link source and link destination buses, and link
table information.
2
Using any of the following methods, select what setting applies to.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
1
Parameter Adjustment
Soft Default value of wipe edge
softness
Parameter Adjustment
Link No Link number
Setting values
–
50.00 to +50.00
Setting values
1 to 64
Setup Relating to Switcher Processor
377