Sony DVS-9000 User Manual page 162

Production switcher system

Hide thumbs Also See for DVS-9000:

Table of Contents

START TC remains the same, and STOP TC changes.

Press the [SET DUR] button, and enter "200" from the numeric keypad

control block.

Press the [SET STOP TC] button, and enter "01000000" from the numeric

keypad control block.

This automatically sets START TC.

Press the [SET STOP TC] button, and without entering anything from the

numeric keypad control block, press [Enter].

The STOP TC display, and the START TC display automatically

calculated in step 2 disappear, and the setting of the DUR does not change.

a) If after pressing the [SET XX] button you press the [ + / – ] button in the numeric keypad

control block, you can enter offsets from the existing setting values. Each time you press

this button, the sign of the offset cycles through the settings " "(absolute value) t "+" t

"... , and the sign appears in the numeric keypad control block display. If there is no

existing setting value, then it is only possible to enter an absolute value, and not an offset

Setting the start point, stop point, and start delay time in a menu

In the Device menu, you can set the start point, stop point, and start delay time.

In the Device menu, press VF3 'DDR/VTR' and HF1 'Cueup & Play.'

The Device >DDR/VTR >Cueup & Play menu appears.

The status area shows the device number, register number, status

information, current time, start point, stop point, and start delay time.

Control of VTRs, Extended VTRs, and Disk Recorders