Sony DVS-9000 User Manual page 348

• Action list when the trigger type is only "Rising Edge" or "Falling Edge"
• Action list when the trigger type is "Level"
b) When knob 2 selection is "Key Snapshot"
c) When knob 2 selection is "Snapshot" or "Shotbox"
d) When knob 2 selection is "Effect"
e) When knob 2 selection is "Aux ? O'ride Src ??"
f) When knob 2 selection is "Prefs Button?"
6
Press [Action Set] to confirm the action selection.
The selected setting appears in the status area.
Carrying out level settings
To set the low level and high level, first set the trigger type to "Level," then use
the following procedure.
1
In the Panel >Device Interface menu, select the action to be set, and press
[H/L Set].
The H/L Set menu appears.
When Target is P/P: Cut, Auto Trans
DSK1 Cut, DSK2 Cut, DSK3 Cut, DSK4 Cut
DSK1 Auto Trans, DSK2 Auto Trans, DSK3 Auto Trans, DSK4 Auto Trans
DSK1 SS ? Recall, DSK2 SS ? Recall, DSK3 SS ? Recall, DSK4 SS ? Recall
FTB Cut, FTB Auto Trans
When Target is Common/Setup: Master SS ? Recall, Master Effect ? Recall, SS ?
Recall, Effect ? Recall, Effect ? Recall & Run, KF Run, KF Stop, KF Rewind, FM
Src1 Frame Freeze, FM Src1 Field Freeze, FM Src1 Freeze Off, FM Src2 Frame
Freeze, FM Src2 Field Freeze, FM Src2 Freeze Off, FM Src1 Clip Record, FM
Src1 Clip Stop, FM Src2 Clip Record, FM Src2 Clip Stop, FM1 to FM8 Clip
Cueup, FM1 to FM8 Clip Play, FM1 to FM8 Clip Stop, Shotbox ? Recall, Macro
Take, Prefs Buttons?, Macro ? Recall, No Action
Aux? O'ride Src??
When Target is M/E-1, M/E-2, M/E-3, or P/P: No Action
When Target is Common/Setup: Format (Overall system settings, frame/field rate,
number of lines)
Aspect (overall system settings), Simul, Level Enable, No Action
Notes
• "Level Enable" is a function that determines whether GPI inputs are enabled
("Enable") or disabled ("Disable") for the "Aspect" and "Format" actions that can
be used when the trigger type is Level. When Level Enable is used, if the input is
"Disable" then it is not possible to switch "Aspect" or "Format" by GPI input.
If a GPI to switch "Aspect" or "Format" occurs when powering the system off, the
action triggered by the GPI may start immediately before the power goes off and
the power may go off before the action is completed. This may corrupt the setup
settings. It is therefore recommended to use Level Enable to avoid such a situation.
• As for "Aux ? O'ride Src ??," when "Rising Edge" is selected, on a rising edge the
set AUX bus primary input is used. On a falling edge, the original state of the cross-
point is restored. If the GPI trigger is applied repeatedly at short intervals (0.5
second or less), the cross-point switching may not be carried out correctly. In this
case, apply the GPI trigger again.
Setup Relating to Operations From the Control Panel
347