Sony DVS-9000 User Manual page 361

Adjusting the alarms
In the Panel >Maintenance menu, make the following settings.
To give audible feedback from menu touch screen operations: Press
Calibrating the touch panel
1
2
3
4
Setting the menu to be shown when the menus are started
1
2
Note
To enable this setting, the initial state of the control panel when powered on
must be set to one of the following.
• Set to Resume mode
• Set to Custom mode, with "User" selected in the <Setup> group.
For details of these settings, see "Selecting the State After Powering On (Start
Up Menu)" (page 278).
360
Setup Relating to Operations From the Control Panel
[Touch Beep], turning it on.
In the Panel >Maintenance menu, press [Touch Panel Calibration].
The following message appears.
"To Perform Calibration, please touch the center of each plus sign."
Press [Yes].
Press the center of the plus sign displayed on the screen.
When you press on the plus sign, it disappears and a diagonally opposite
plus sign appears.
Press the center of the plus sign.
A confirmation message appears.
• Select "Yes" to restart the panel reflecting the new setting.
• Select "No" to cancel the setting and return to the Maintenance menu.
In the Panel >Maintenance menu, press [Initial Menu Set].
A popup window appears.
Enter the page number of the desired menu.
The next time the menus are started, the menu specified by this number
appears.