Sony DVS-9000 User Manual page 145

4
5
Repeat steps 2 to 5 as required for other devices.
Testing an action command
To produce a test output of the action command, press [Test Fire].
The action command is output from the 9-pin serial port of the DCU according
to the setting in the list on the left of the status area.
Clearing an action setting
To clear the setting for separate devices
1
2
3
To clear the action settings for all devices in a single operation
Press [All Off].
144
Control of P-Bus Devices
3: Recall
4: Trigger
If in step 3 you selected 2 (Store), 3 (Recall), or 4 (Trigger), turn knob 3 to
select the register number or trigger number.
The indication for knob 3 changes to reflect the selection of Store, Recall,
or Trigger.
Knob Parameter
3 Store No
3 Recall No
3 Trigger No
The setting is reflected in the list on the right of the status area.
Press [Set].
For the device selected in the list on the left of the status area, this sets the
action specified in step 4.
In the list on the left of the status area, select the device for which you want
to clear the action setting.
In the list on the right, select "Off."
Press [Set].
Adjustment
Register number for Store
Register number for Recall
Trigger number
Setting values
1 to 99
1 to 99
0 to 15