Ccd Main Zoom - Xerox Phaser 6115MFP Service Manual

Adjustments and Print Function Settings

CCD Main Zoom

6-12
Procedure:
1. Print the test pattern 1.
C
2. Check width C on the printed page produced.
3. Check that the width of C in the test pattern 1 meets the specification. If
the width of C is out of specification, adjust it according to the following
procedure.
a. Enter the [2. ADJUST] menu in the service mode.
b. Select [PRN SUB REGIST] of [2. ADJUST] and press the Menu
Select key twice.
c. Using the p/q key, change the setting value and then press the Menu
Select key.
d. Print a test pattern 1 again and check it.
Adjustment:
Instructions If the width of C in the test pattern is longer than the specified
width..... Increase the setting.
If the width of C in the test pattern is shorter than the specified width.....
Decrease the setting.
Function:
To adjust for variations in the accuracy of Scanner parts and their mounting
accuracy by varying the scanning zoom ratio in the main scanning direction.
Use:
When the Scanner unit has been replaced.
Note
After the [PRN MAIN REGIST] and [PRN SUB REGIST] adjustments
have been performed
Adjustment:
Adjust the width of D in the copy of the test pattern 1 so that the following
specification is met.
s6115-504
Phaser 6115MFP Multifunction Product Service Manual