Adf Sub Regist; Dmax (Manufacturing Only); 1St Transfer Voltage (Manufacturing Only) - Xerox Phaser 6115MFP Service Manual

Adjustments and Print Function Settings

ADF Sub Regist

DMAX (Manufacturing Only)

1st Transfer Voltage (Manufacturing Only)

6-20
5. The test pattern 1 should be positioned vertically. Use A4 or Letter paper
loaded into tray1 to make the test copy.
Check the amount that widths A and B in the copy of the test pattern
are shifted.
If the shift is out of specification, adjust it according to the following
procedure.
Press the Menu Select key.
Using the ../.. key, change the setting value and then press the Menu
Select key.
Place the test pattern 1 into the Automatic Document Feeder. Then,
make a test copy again and check it.
If the width of A is less than the width of B..... Increase the setting.
If the width of B is less than the width of A..... Decrease the setting.
Function:
To adjust for variations in the accuracy of all parts and their mounting
accuracy by varying the scanning start position in the sub-scanning direction
when using the Automatic Document Feeder.
Use:
When the original glass is replaced, or when a new Auto Document Feeder
Unit is mounted.
Note
After the [PRN MAIN REGIST] and [PRN SUB REGIST] and [CCD SUB
ZOOM] adjustments have been performed
After the [ADF SUB ZOOM] adjustments have been performed, refer to the
Adjustment Range section of the Auto Document Feeder Unit.
Function:
To adjust the density of each color.
Function:
To adjust the voltage applied to the Transfer Roller for each color.
Phaser 6115MFP Multifunction Product Service Manual