Faulty Scanner Exposure Lamp - Xerox Phaser 6115MFP Service Manual

Error Codes and Messages
102H Faulty Scanner Exposure Lamp
Applicable Status Code
Initial Actions
3-30
Troubleshooting Procedure Table
Step Action and Questions
Check the lock lever of the scanning unit.
1
Is the lever locked?
Check the Scanner Motor connector
2
CN10 for proper connection. Is the
connector seated properly?
Check the Engine Control Board
3
connector P/J8 for proper connection. Is
the connector seated properly?
Check the operation of the Scanner
4
Motor.
Is the motor operational?
Replace the Engine Control Board
5
(page 8-57).
Is the system operational?
6 Replace the DC Power Supply 2
(page 8-68).
Is the system operational?
Replace the DC Power Supply 1
7
(page 8-60).
Incorrect printer exposure.
102H:

Faulty Scanner Exposure Lamp

Remove power from the system and reboot.
Print a test page.
Yes
Unlock the lock
lever. If the
problem
persists, go to
Step 2.
Go to Step 3.
Go to Step 5.
Go to Step 5.
Complete
Complete
Complete
Phaser 6115MFP Multifunction Product Service Manual
No
Go to Step 2.
Reseat the
connector. If the
problem
persists, go to
Step 3.
Reseat the
connector, then
go to Step 5.
Check pulse
output pins 1
thru 4 on P/J8.
If no output, go
to Step 5.
Go to Step 6.
Go to Step 7.