Transfer Belt Rotation Failure - Xerox Phaser 6115MFP Service Manual

16H Transfer Belt Rotation Failure
Phaser 6115MFP Multifunction Product Service Manual
Faulty belt rotation.
Applicable Status Code
16H:

Transfer Belt Rotation Failure

Initial Actions
Remove power from the system and reboot.
Print a test page.
Troubleshooting Reference Table
Applicable Parts
Transfer Belt Unit, PL4.15.5
Warning
To avoid the potential of electric shock, ensure the power to the printer is
off and the power cord is disconnected from the wall outlet prior to
performing each step of the following troubleshooting procedure.
Troubleshooting Procedure Table
Step Action and Questions
Check the Engine Control Board
1
connector P/J9 and the Belt Positioning
sensor connector P/J37. Are the
connectors seated properly?
Replace the Engine Control Board
2
(page 8-57) and reboot.
Is the system operational?
Replace the Transfer Belt Unit
3
(page 8-33).
Error Codes and Messages
Wiring and Plug/Jack References
Print Engine Wiring Map (page 10-12)
Map 1 - Engine Control Board Plug/Jack Locator
(page 10-5)
Yes
Go to Step 2.
Complete
Complete.
No
Reseat the
connectors and
go to Step 2.
If the problem
persists, go to
Step 3.
3-21