Faulty Waste Toner Near Full Detection Board - Xerox Phaser 6115MFP Service Manual

Error Codes and Messages
23H Faulty Waste Toner Near Full Detection Board
Applicable Status Code
Initial Actions
3-26
Incorrect detection of waste toner.
23H:

Faulty Waste Toner Near Full Detection Board

Remove power from the system and reboot.
Print a test page.
Troubleshooting Reference Table
Applicable Parts
Waste Toner near full detect
board, PL4.6.6
Imaging Unit, PL4.15.9
Engine Control Board,
PL4.19.15
Warning
To avoid the potential of electric shock, ensure the power to the printer is
off and the power cord is disconnected from the wall outlet prior to
performing each step of the following troubleshooting procedure.
Troubleshooting Procedure Table
Step Action and Questions
Check the WTDTB/LED connector P/J1
1
for proper connection. Is the connector
seated properly?
Check the Engine Control Board
2
connector P/J13 for proper connection.
Is the connector seated properly?
3 Replace the Imaging Unit (page 8-13). Is
the system operational?
Replace the WTDTB/LED Board
4
(page 8-70). Is the system operational?
5 Replace the Engine Control Board
(page 8-57). Is the system operational?
Wiring and Plug/Jack References
Print Engine Board Plug/Jack Designators
(page 10-3)
Print Engine Wiring Map, page 10-12
Engine Control Board to Solenoid and Sensor
Wiring (page 10-13)
Yes
Go to Step 2.
Go to Step 3.
Complete
Complete
Complete.
Phaser 6115MFP Multifunction Product Service Manual
No
Reseat the
connector and
go to Step 2.
Reseat the
connector and
go to Step 3.
Go to Step 4.
Go to Step 5.