Misfeed At Exit Section - Xerox Phaser 6115MFP Service Manual

Misfeed at Exit Section

Phaser 6115MFP Multifunction Product Service Manual
Troubleshooting Procedure Table (Continued)
Step Action and Questions
5 Replace the Image Processor Board
(page 8-55). Does the problem still
persist?
6 Replace the Engine Control Board
(page 8-57).
For detection of misfeed, the Exit sensor is not unblocked even after the lapse
of a predetermined period of time after it has been blocked by the paper. In
some cases, the Exit Tray Full sensor is not blocked even after the set period
of time has elapsed after the exit sensor has been blocked by the paper.
For detection of paper left in the exit section, the Exit Sensor is blocked when
the power switch is turned ON, a cover is opened and closed, or a misfeed or
malfunction is reset. For detection of paper loaded fully in the exit section, the
Exit Tray Full sensor is blocked when the power switch is turned ON, a cover
is opened and closed, or a misfeed or malfunction is reset.
Troubleshooting Reference Table
Applicable Parts
Exit Sensor, PL4.18.9
Exit Tray Full Sensor, PL4.1.7
Registration Roller Solenoid,
PL4.12.3
Engine Control Board,
PL4.19.15
Warning
To avoid the potential of electric shock, ensure the power to the printer is
off and the power cord is disconnected from the wall outlet prior to
performing each step of the following troubleshooting procedure.
Troubleshooting Procedure Table
Step Action and Questions
1 Check all Engine Control Board
connectors.
Are the connectors seated properly?
Check the Exit sensor at P/J6 (pin 3). Is
2
the sensor operational?
Yes
Go to Step 6.
Complete
Wiring and Plug/Jack References
Boards and Power Supplies Locator (page 1-14)
Sensors and Switches Locator (page 1-16)
Solenoids and Power Switch Locator
(page 1-17)
Engine Control Board to Miscellaneous Motor
and Sensor Wiring (page 10-17)
Engine Control Board to Main Motor and
Positioning Sensor Wiring (page 10-16)
Yes
Go to Step 2.
Go to Step 3.
General Troubleshooting
No
Complete
No
Reseat the
connectors. If
the problem
persists, go to
Step 2.
Replace the
sensor
(page 8-122).
4-7