Connecting An Acx5000 Router To A Network For Out-Of-Band; Management; Figure 42: Connecting The Acx Router Directly To A Management Console - Juniper ACX5048 Manual

ACX5048 and ACX5096 Universal Access Router
Related
Documentation
Connecting an ACX5000 Router to a Network for Out-of-Band Management
122

Figure 42: Connecting the ACX Router Directly to a Management Console

Console Port Connector Pinouts for an ACX5000 Router on page 58
You can monitor and manage the ACX5000 router using a dedicated management
channel. ACX5000 routers have a minimum of two management ports:
a 10/100/1000BASE-T RJ-45 port and a 1-Gbps SFP ports. Some product SKUs have an
additional 1-Gbps SFP port that can be used either for fiber or copper connections. Use
the management ports to connect the ACX5000 router to a network for out-of-band

management.

CAUTION: Configuring the two management interfaces within the same
subnet is not supported.
NOTE: You cannot use the management ports to perform the initial
configuration of the ACX5000 router. You must configure the management
ports before you can successfully connect to the ACX5000 router using these
ports. See "Configuring an ACX5000 Router" on page
Ensure that you have an appropriate cable available. See
and Management Connections for an ACX5000 Router" on page 93
Specifications for SFP, SFP+, and QSFP+ Transceivers for an ACX5000 Router" on
page 62.
To connect a ACX5000 router to a network for out-of-band management (see
Figure 43 on page 123):
Connect one end of the cable to one of the management ports (labeled
1.
) on the ACX5000 router.
C1
Connect the other end of the cable to the management router (see
2.
Figure 43 on page 123).
125.
"Cable Specifications for Console
and "Interface
C0 and
Copyright © 2015, Juniper Networks, Inc.