Interface Specifications For Sfp, Sfp+, And Qsfp+ Transceivers For An Acx5000 Router - Juniper ACX5048 Manual

ACX5048 and ACX5096 Universal Access Router
Interface Specifications for SFP, SFP+, and QSFP+ Transceivers for an ACX5000
Router
62
This topic describes the specifications for the SFP, SFP+, and QSFP+ transceivers used
in ACX5000 routers.
The optical transceivers installed in ACX5000 devices support digital optical monitoring
(DOM): you can view the diagnostic details for these transceivers by issuing the operational
mode CLI command show interfaces diagnostics optics
output for copper transceivers or transceivers not purchased from Juniper Networks.
The three tables in this topic describe the optical interface support over single-mode
fiber-optic (SMF) and multimode fiber-optic (MMF) cables and copper interface support
over four-pair, Category 5 shielded twisted-pair cables:
Table 33 on page 63—Copper interface support and optical interface support for
Gigabit Ethernet SFP transceivers.
Table 34 on page 66—Optical interface support for 10-Gigabit Ethernet SFP+
transceivers.
Table 35 on page 71—Optical interface support for 40-Gigabit Ethernet QSFP+
transceivers.
NOTE: If you are using the -QSFP-40G-ESR4 transceiver in an access port
and have configured the port to operate as multiple 10-Gigabit Ethernet
interfaces, you can use a fiber breakout cable to distribute the interfaces
to up to four 10GBASE-SR SFP+ transceivers. Juniper Networks does not
sell fiber breakout cables.
. The command does not give any
Copyright © 2015, Juniper Networks, Inc.