Table of Contents
Advertisement
ICP-CC408 | Installation Guide | 6.0
When using a partitioned ICP-CC408 Control Panel,
the Master Code holder cannot add, change, or
delete User Codes unless the User Code is allocated
to the same area as the Master Code. Refer to Section
13.3 User Code Priority on page 55 for more
information.
1. Enter your Master Code and press [1][AWAY].
Three beeps sound and the STAY and AWAY
indicators flash.
2. Enter the number of the code (1 to 8) you want
to change and press [AWAY].
Two beeps sound and the corresponding zone
indicator lights. Refer to Table 32.
3. Enter the new code and press [AWAY].
Two beeps sound and the STAY and AWAY
indicators are extinguished.
4. Repeat this procedure to change other User
Codes.
This function is terminated automatically if
you do not press a button within 60 sec
or if you press [AWAY].
One long beep indicates that the code
already exists or that you entered an
incorrect user number.
Example
To program User Code number 2 as 4627, enter:
[2 5 8 0 1][AWAY][2][AWAY][4 6 2 7][AWAY]
To delete a User Code:
1. Enter your Master Code and press [1][AWAY].
Three beeps sound and the STAY and AWAY
indicators flash.
2. Enter the number of the code (1 to 8) you want
to delete and press [AWAY].
Two beeps sound and the corresponding zone
indicator lights. Refer to Table 32.
3. Press [STAY] to delete the User Code.
Two beeps sound and the STAY and AWAY
indicators are extinguished.
4. Repeat this procedure to delete other User
Codes.
This function is terminated automatically if
you do not press a button within 60 sec
or if you press [AWAY].
One long beep indicates that the code
already exists or that you entered an
incorrect user number.
Bosch Security Systems, Inc. | 12/08 | F01U089463-02
System Functions
Table 32: User Numbers Displayed by the
User
Number
1
2
3
4
5
6
7
8
Example
To delete user code number 3, enter:
[2 5 8 0 1][AWAY][3][AWAY][STAY]
6.2.3
Changing and Deleting Remote Radio
User Codes
This function allows a Master Code holder to change
or delete a remote radio User Code.
To add or change a remote radio User Code:
1. Enter your Master Code and press [1][AWAY].
Three beeps sound and the STAY and AWAY
indicators flash.
2. Enter the number of the code (9 to 16) you want
to change and press [AWAY].
Two beeps sound and the corresponding
codepad indicators light. Refer to Table 33 on
page 35.
3. Press any of the [TRANSMIT] buttons on the
hand-held transmitter.
Two beeps sound and the STAY and AWAY
indicators are extinguished.
4. Repeat this procedure to change other remote
radio User Codes.
This function is terminated automatically if
you do not press a button within 60 sec
or if you press [AWAY].
One long beep indicates that the code
already exists or that you entered an
incorrect user number.
Codepad Indicators
Zone Indicators
1
2
3
4
5
6
X
X
X
X
X
EN | 34
7
8
X
X
X
Advertisement
Table of Contents
