Special Point/User Reporting; Table 2: Modem Iiia 2 Communication Format Data - User Id Numbers; Table 3: Modem Iiia 2 Communication Format Data - Point Numbers - Bosch D7212GV3 Program Entry Manual

D7212GV3 | Program Entry Guide | 2.0
When the keypad reads Parameter Saved, your
selection has been configured
Point/User Flag
Default: Yes
Selection:
Yes or No
Yes The control panel sends a flag with
each report telling the central station
receiver to convert point numbers
and User ID numbers to COMEX
format. Refer to Table 2 and Table 3
for conversion information. When this
parameter is programmed Yes,
points and User ID numbers are
converted, regardless of the
programming of the central station
receiver for output to the computer
system. Refer to Appendix C in the
Conettix D6600/D6100
Receiver/Gateway Computer
Interface Manual (P/N: 4998122703).
No The control panel does not send the
flag. The central station receiver
outputs point numbers as 001 to 040
(rather than 100 to 216) and User ID
numbers as 000 to 099 (rather than
000 to F08), as indicated in Table 2
and Table 3.
This program item determines how point and User ID
numbers are presented at the central station receiver
display, printer, and computer RS-232 output.
When Phone # Format is Yes, the control panel
sends expanded Bosch Modem IIIa
Format reports to the central station receiver. If your
central station data files are not set up for point and
User ID number reporting, you can use this program
item to convert these numbers to COMEX Reports.
When Phone # Format is Yes, the control panel
sends expanded Bosch Modem IIIa
Format Reports to the receiver. Point/User Flag
affects Bosch Modem IIIa
data as shown in Table 2. The Bosch Security
Systems, Inc. D6600 Receiver adds the leading zero
in the User ID number with Point/User Flag
programmed No.
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
Panel and Area Wide Parameters
2
Communication
2
Communication
2
Communication Format
2
Table 2: Modem IIIa
Data - User ID Numbers
Point/User Flag
NO
000
001 to 005
006 to 013
014 to 021
022 to 029
030 to 037
038 to 045
046 to 053
054 to 061
062 to 069
070 to 099
2
Table 3: Modem IIIa
Data – Point Numbers
Point/User Flag
NO
001 to 008
009 to 024
025 to 040
041 to 056
2.2.1

Special Point/User Reporting

Independent Zone Control Notice: When using
Independent Zone Controls (IZC) to send
Opening/Closing Reports by point, do not duplicate
reporting independent point numbers with User ID
Reports (refer to Section 3.1 Passcode or Token
Worksheet on page 74). For example: If an IZC is
connected to Point 8, do not use User ID 8.
D6000: Opening/Closing User ID numbers are
identified at the receiver as zones (same
identification as independent points).
EN | 10
Communication Format
Point/User Flag
YES
000
001 to 005
601 to 608
701 to 708
801 to 808
B01 to B08
C01 to C08
D01 to D08
E01 to E08
F01 to F08
000
Communication Format
Point/User Flag
YES
100 to 800
101 to 116
201 to 216
301 to 316