Removing the front bezel and top cover
To install option cards or DIMMs, you must remove the front bezel and the top
cover from the gateway.
To remove the front bezel:
1
Shut down the Contivity 1600 or 1700 using the Web GUI or the command
line interface and then unplug it as described in
add or replace hardware" on page
2
Using a Phillips screwdriver, turn each of the 2 screws on the front bezel a
quarter turn counterclockwise
Figure 10 Removing the front bezel
3
Grip the two handles and firmly pull the bezel toward you to unsnap it from
the chassis.
Chapter 3 Contivity 1700 and 1600 option installation 41
Danger: Make sure to turn off the gateway and unplug it before you
attempt to install an option card or DIMM.
Caution: Do not use the piece with the Nortel Networks logo and the
LEDs as a handle.
Installing Hardware Options for the Contivity Secure IP Services Gateway
"Shutting down the system to
40.
(Figure
10).
CS160014A