Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
1.1
Removing and installing multiple clutch
Special tools and workshop equipment required
♦ Assembly sleeve -T10302-
♦ Retaining pin -T10303-
Note
Assembly sleeve -T10302- must be cleaned before use; do not
use an assembly sleeve if it is scratched.
Removing
Proceed as follows:
– Drain off gear oil
⇒ page 72
.
– Remove direct shift gearbox
⇒ page 43
.
– Secure direct shift gearbox to assembly stand in vertical po‐
sition
⇒ page 57
.
– Renew gear oil filter
⇒ page 78
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
13
1. Servicing multiple clutch - exploded view