Controls, Housing - Audi TT 2007 Workshop Manual

34 –

Controls, housing

1 Electrical/electronic components and fit‐
ting locations
Diagnostic connector
Fitting location: below knee padding on left side of steering wheel.
Selector lever lock solenoid -N110-
Fitting location: the selector lever lock solenoid -1- is located in
the selector mechanism.
The solenoid is integrated in the selector mechanism; it is there‐
fore not possible to renew only the solenoid on its own. It can only
be removed or installed together with the selector mechanism
⇒ page 33 .
Mechatronic unit for direct shift gearbox -J743-
Fitting location: the mechatronic unit for direct shift gearbox -
J743- is bolted to the front of the gearbox housing and covered
by the gearbox oil pan.
The control unit is an integrated component of the mechatronic
unit for direct shift gearbox -J743- .
♦ Checked via self-diagnosis
⇒ "1.3 Removing and installing mechatronic unit for direct shift
gearbox J743 ", page 85
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi TT 2007 ➤
23
1.