Audi TT 2007 Workshop Manual page 43

– Shift selector lever to position "S".
– Pull down locking plate -1- for selector lever cable and remove.
– Pull plastic retaining spring -2- forwards slightly and press piv‐
ot pin -3- upwards only as far as necessary -arrow-.
Note
Ensure that pin is not pressed out completely.
– Pull selector lever cable -4- out of shift unit.
Note
Do not bend or kink the selector lever cable.
Installing
• Tightening torques ⇒ page 30
Installation is carried out in reverse sequence; note the following:
Note
Renew locking plates and retaining clip for selector lever ca‐
♦
ble.
The selector lever cable must be renewed if the sleeves are
♦
damaged.
– Guide selector lever cable into cover for shift unit, taking care
not to damage sleeve.
– Engage sleeve in cover for shift unit.
Note
Check that the sleeve is seated correctly and not twisted.
– Insert end of selector lever cable -4- into joint on selector lever.
– Press pivot pin -3- downwards -arrow-.
• The plastic securing spring -2- should lock the pin in position.
– Secure selector lever cable to shift unit using new locking plate
-1-.
• Installation position: angled end of locking plate faces shift
unit.
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi TT 2007 ➤
3. Servicing selector mechanism - exploded view
39