Audi TT 2007 Workshop Manual page 83

– Place used oil collection and extraction unit -V.A.G 1782- un‐
der gearbox.
– Unscrew housing for gear oil filter.
Note
To allow the gear oil to drain back into the gearbox from the hous‐
ing for the gear oil filter, tilt the housing slightly in its seat before
removing it.
– Then lift out filter element slowly.
Note
If the O-ring on the intake neck -arrow- of the filter element does
not come off together with the filter element, you must remove it
from the gearbox separately.
Installing
• Tightening torque ⇒ page 76
Installation is carried out in reverse sequence; note the following:
Note
Renew filter element and O-ring on oil filter housing.
– Lightly lubricate O-ring on intake neck -arrow- of filter element
with gear oil.
– Install filter element with intake neck facing downwards.
– Lightly lubricate O-ring on housing of gear oil filter with gear
oil.
– Tighten filter housing.
– Check gear oil level and top up as required
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
.
⇒ page 66 .
10. Gear oil cooler and gear oil filter - exploded view
Audi TT 2007 ➤
79