Audi TT 2007 Workshop Manual page 38

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
– Unplug electrical connector -A-.
Note
-Items 1, B, C- can be disregarded.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– Unplug electrical connector -3- from air mass meter -G70- .
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Release clamps -1 and 2- and disconnect air intake hose from
air mass meter -G70- .
– Unbolt front intake duct from lock carrier -4-.
– Remove engine cover panel.
– Shift selector lever into position "P".
– Detach locking plate -C-.
– Press retaining clip -A- upwards and detach.
– Press selector lever cable off selector shaft lever -arrow- and
pull out of support bracket -D-.
Note
Do not bend or kink the selector lever cable.
♦
-Items 1 and B- can be disregarded.
♦
– Remove Lambda probe after catalytic converter -G130- ⇒
Rep. Gr. 24 .
– Remove tunnel brace and bracket for exhaust system
-arrows-.
34
Rep. Gr.34 - Controls, housing