Audi TT 2007 Workshop Manual page 92

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
– Put down the mechatronic unit correctly.
Caution
The mechatronic unit can be damaged.
♦ Do not lift the mechatronic unit by the sender "arm" or put
down the unit so it rests on the sender arm.
Note
The mechatronic unit must be renewed if the sender "arm" is
damaged.
Installing
• Tightening torques ⇒ page 80
Installation is carried out in reverse sequence; note the following:
Note
Renew bolts for mechatronic unit for direct shift gearbox -
♦
J743- and for cover for gear oil pump.
Renew cover for gear oil pump.
♦
When re-installing, renew O-rings -arrows- on connector for
♦
mechatronic unit for direct shift gearbox -J743- .
The O-rings are supplied with the replacement unit if the me‐
♦
chatronic unit for direct shift gearbox -J743- is being renewed.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Carefully fit mechatronic unit for direct shift gearbox -J743- in
gearbox housing.
• The mechatronic unit must be fitted onto the dowel pins
-arrow-.
• The "sender arm" must fit in the guide in the gearbox housing
as shown in the detail view.
• The electrical wiring for -G182- and -G509- must not become
trapped.
88
Rep. Gr.35 - Gears, shafts
, ⇒ page 81