Audi TT 2007 Workshop Manual page 64

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
❑ Gearbox mounting to gearbox support
❑ Renew
15 - Bolt
❑ 40 Nm + 90°
❑ Gearbox mounting to body
❑ Renew
16 - Gearbox mounting
❑ Removing and installing
❑ Tightening sequence
17 - Bolt
❑ 40 Nm + 90°
❑ Gearbox support to gearbox
❑ Renew
18 - Bolt
❑ 40 Nm + 90°
❑ Gearbox support to gearbox
❑ Renew
19 - Gearbox support
❑ Tightening sequence
Assembly mounting on gearbox side: tightening sequence
– Fit gearbox support -A- between gearbox and support arm of
gearbox mounting.
– Bolt gearbox support to gearbox.
– Pull gearbox up to support arm of gearbox mounting using
spindle of support bracket -10 - 222 A- .
– Screw in bolts -2- initially hand-tight.
Caution
Screw in bolts straight when fitting as otherwise the threads in
the support arm of the gearbox mounting will be damaged.
♦ Before fitting the bolts -2-, the gearbox support and the
support arm of the gearbox mounting must be aligned ab‐
solutely parallel. If necessary, push the gearbox up at the
rear with a trolley jack.
– Only tighten bolts after subframe has been installed ⇒ Rep.
Gr. 40 and assembly mountings aligned ⇒ Rep. Gr. 10 .
60
Rep. Gr.34 - Controls, housing
⇒ page 61
⇒ page 60
⇒ page 60
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.