Audi TT 2007 Workshop Manual page 90

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
– Remove noise insulation (left-side) -arrows-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Note
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
In order to pull the mechatronic unit out of the gearbox without
damage, you must first remove the cover for the gear oil pump.
– Unscrew bolts -arrows- and detach cover for gear oil pump
-A-.
Caution
The mechatronic unit can be damaged by electrostatic dis‐
charge.
♦ Do not touch the contact pins in the connector with bare
hands.
– Touch vehicle earth with your hand (without gloves) to dis‐
charge any static electricity.
Caution
The electrical wiring can be damaged.
♦ Do not pull on the electrical wiring.
– Using a small screwdriver -arrow-, carefully release electrical
connector for gearbox input speed sender -G182- and clutch
temperature sender -G509- and unplug connector.
Note
-G182- and -G509- will have to be renewed if the electrical wiring
is damaged.
86
Rep. Gr.35 - Gears, shafts