Removing And Installing Flange Shaft (Right-Side) - Audi TT 2007 Workshop Manual

– Carry out steps required for removing drive shaft (left-side);
however, bolt -2- securing drive shaft -1- to wheel hub does
not have to be removed ⇒ Rep. Gr. 40 .
– Move drive shaft (left-side) clear to the side and tie in position.
– Place used oil collection and extraction unit -V.A.G 1782- be‐
low gearbox.
– Remove bolt securing flange shaft (left-side). To do so, screw
two bolts into flange and counterhold flange shaft with suitable
lever.
– Pull out flange shaft together with spring, thrust washer and
tapered ring.
Installing
• Tightening torque
Installation is carried out in reverse sequence; note the following:
– Push flange shaft in against spring pressure securing bolt.
– Install drive shaft (left-side) ⇒ Rep. Gr. 40 .
– Secure swivel joint to wishbone ⇒ Rep. Gr. 40 .
– Secure coupling rod to anti-roll bar ⇒ Rep. Gr. 40 .
– Check gear oil level and top up as required
1.2 Removing and installing flange shaft
(right-side)
Special tools and workshop equipment required
♦ Used oil collection and extraction unit -V.A.G 1782-
Removing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Proceed as follows:
with respect to the correctness of information in this document. Copyright by AUDI AG.
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
⇒ page 93 .
⇒ page 66 .
1. Flange shafts and oil seals - exploded view
Audi TT 2007 ➤
95