Subframe, Removing And Installing - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
10 - Thrust washer
❑ The opening points opposite the direction of travel.
❑ Only on V8 TDI from MY 11.
❑ For the correct allocation, refer to the Parts Catalog.
11 - Bolt
❑ 120 Nm + 180°
❑ Always replace if removed.
12 - Self-Locking Nut
❑ 180 Nm
❑ Always replace if removed.
13 - Eccentric Washer
14 - Eccentric Screw
15 - Lower Control Arm
❑ Conical pin must be free of grease and oil.
❑ If necessary, clean using dry rag, do not use cleaning agents.
16 - Bolt
❑ 120 Nm + 180°
❑ Always replace if removed.
17 - Self-Locking Nut
❑ 110 Nm
❑ Always replace if removed.
18 - Coupling Rod
❑ Removing and Installing, refer to
19 - Bolt
20 - Suspension Strut
21 - Self-Locking Nut
❑ 110 Nm
❑ Always replace if removed.
22 - Bolt
23 - Stabilizer Bar
❑ Removing and Installing, refer to
24 - Stabilizer Bar Bearing
❑ Note stabilizer bar mount location, refer to
25 - Clamp
26 - Bolt
❑ 60 Nm
2.2

Subframe, Removing and Installing

Special tools and workshop equipment required
♦ The following tools can be used on all engine versions. The
tools needed for working on a specific engine are described,
refer to ⇒ page 20 .
♦ Engine Support Bridge - 10-222A-
♦ Engine Support Bridge - Sub-frame Adapter - 10-222A/22-
♦ Engine Support - Bracket w/Spindle and hook - 10-222A/10-
18
Rep. Gr.40 - Front Suspension
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ "2.6 Coupling Rod, Removing and Installing", page 43
⇒ "2.5 Stabilizer Bar, Removing and Installing", page 40
⇒ Fig. ""Stabilizer Bar Bearing Location"" , page 42
.
.
.