Audi TT 2007 Workshop Manual page 25

– Fit new circlip for drive plate.
• Installation position: the lug on the drive plate and the colour-
marked splines on the outer plate carrier (or the corresponding
marks made previously) must be located between the ends of
the circlip.
– Using a screwdriver, check that circlip is fully engaged.
– Take out retaining pin -T10303- between multiple clutch and
housing.
Caution
Leakage can occur at the contact surface of the clutch end
cover.
♦ Thoroughly degrease running surface -arrow- on drive
plate for internal seal of clutch end cover.
– Clean the contact surface for the outer seal of the clutch end
cover.
Caution
Leakage can occur at the internal seal for the clutch end cover.
♦ To ensure that the internal seal remains absolutely free of
grease, do not touch the seal with your hands.
– Take the clutch end cover out of its packaging, only taking hold
of it on the outside as illustrated.
– Clean end of gearbox shaft.
Note
Using gear oil, lightly lubricate the outer seal for the clutch end
♦
cover only.
If there are any stickers on the inside or the outside of the
♦
clutch end cover, remove them thoroughly.
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi TT 2007 ➤
1. Servicing multiple clutch - exploded view
21