Audi TT 2007 Workshop Manual page 31

Removing
Proceed as follows:
Note
The selector lever handle is removed together with the selector
lever boot.
– Apply handbrake.
– Shift selector lever into position "N".
– Use a cable tie to secure the interlock button in pulled-out po‐
sition -arrow-, as shown in the illustration.
– Using a small screwdriver, carefully pry out selector lever boot
at the side -arrow 1-.
– Pull up both sides of boot and detach boot -arrows 2 and 3-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Turn selector lever boot -2- inside out over selector lever han‐
dle -3-.
– Release hose clip -1-.
– Pull off selector lever handle together with selector lever boot
-arrow-, taking care not to touch interlock button.
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
2. Selector lever handle, selector lever display illumination bulb L101 - exploded view
Audi TT 2007 ➤
27