Audi TT 2007 Workshop Manual page 81

♦ Hose clamps, up to 25 mm -3094-
Removing
Proceed as follows:
WARNING
Risk of scalding from hot steam and hot coolant.
♦ The cooling system is under pressure when the engine is
hot.
♦ Cover filler cap on expansion tank with a cloth and open
carefully to release pressure.
– Open filler cap on expansion tank.
– Unplug electrical connector -3- from air mass meter -G70- .
– Release clamps -1 and 2- and disconnect air intake hose from
air mass meter -G70- .
– Unbolt front intake duct from lock carrier -4-.
– Remove engine cover panel.
– Clamp off coolant hoses at gear oil cooler using hose clamps
-3094- .
– Disconnect coolant hoses from gear oil cooler.
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi TT 2007 ➤
10. Gear oil cooler and gear oil filter - exploded view
77