Removing And Installing Tiptronic Switch F189 - Audi TT 2007 Workshop Manual

– Remove air cleaner housing (top and bottom sections) ⇒ Rep.
Gr. 24 .
• Selector mechanism and selector lever cable operate smooth‐
ly when changing gears.
• Sleeve on selector lever cable is undamaged.
• Retaining clip -A- is fitted correctly (pressed down and locked).
Note
If the selector mechanism is stiff, renew the selector lever ca‐
♦
ble or service the selector mechanism.
The selector lever cable must be renewed if a sleeve is dam‐
♦
aged.
– Shift selector lever into position "P".
– Slacken bolt -B-.
– Set selector shaft lever on gearbox to position "P".
– Push vehicle forwards until wheels lock so that detent lever in
gearbox engages in parking lock gear.
– To release tension in selector lever cable, carefully move se‐
lector lever slightly forwards and backwards, without shifting
into a different position.
– Tighten bolt -B-, taking care not to alter position of selector
lever cable.
Checking adjustment of selector lever cable
– Keep button pressed, while pulling selector lever approx. 5
mm to the rear out of position "P". Then keep lever in this po‐
sition, do not move it into "R".
– Release selector lever.
• The selector lever should spring back into position "P" by itself.
– Shift selector lever into position "N".
– Keep button pressed, while pulling selector lever approx. 5
mm to the rear out of position "N". Then keep lever in this po‐
sition, do not move it into "D".
– Release selector lever.
• The selector lever should spring back into position "N" by itself.
– Keep button pressed, while pushing selector lever approx. 5
mm to the front out of position "N". Then keep lever in this
position, do not move it into "R".
– Release selector lever.
• The selector lever should spring back into position "N" by itself.
– Repeat the adjustment if the selector lever does not react as
described.
– Check selector mechanism
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.6 Removing and installing tiptronic switch
-F189-
The tiptronic switch -F189- is integrated in the shift unit; it cannot
be renewed separately.
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
⇒ page 32 .
Audi TT 2007 ➤
3. Servicing selector mechanism - exploded view
41