Audi TT 2007 Workshop Manual page 103

Hide thumbs Also See for TT 2007:
Table of Contents

Advertisement

♦ Extractor tool -T20143-
Removing
Proceed as follows:
Note
The oil seal can be renewed with the gearbox installed.
Observe general repair instructions
Observe rules for cleanliness when working on the gearbox
⇒ page 10
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– Remove flange shaft (right-side)
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Pull out oil seal with extractor tool -T20143/2- .
Installing
– Drive in new oil seal as far as stop using thrust piece -3377-
(if tool designation in illustration is different, this can be disre‐
garded).
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
⇒ page 8
.
⇒ page 95
.
Audi TT 2007 ➤
1. Flange shafts and oil seals - exploded view
99

Advertisement

Table of Contents
loading

Table of Contents