Removing And Installing Gear Oil Filter - Audi TT 2007 Workshop Manual

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
– Remove bolts -A-.
– Detach gear oil cooler -B- together with two O-rings -C- from
gearbox.
Caution
Do not allow coolant to drip into gearbox.
Installing
• Tightening torque ⇒ page 76
Installation is carried out in reverse sequence; note the following:
Note
Renew bolts for gear oil cooler.
♦
Renew O-rings.
♦
– Check coolant level ⇒ Rep. Gr. 19 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Check gear oil level and top up as required
with respect to the correctness of information in this document. Copyright by AUDI AG.
10.2

Removing and installing gear oil filter

Special tools and workshop equipment required
♦ Used oil collection and extraction unit -V.A.G 1782-
Removing
Proceed as follows:
– Unplug electrical connector -3- from air mass meter -G70- .
– Release clamps -1 and 2- and disconnect air intake hose from
air mass meter -G70- .
– Unbolt front intake duct from lock carrier -4-.
– Remove engine cover panel.
78
Rep. Gr.34 - Controls, housing
.
⇒ page 66 .