Removing And Installing Flange Shaft (Left-Side) - Audi TT 2007 Workshop Manual

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
1.1 Removing and installing flange shaft
(left-side)
Special tools and workshop equipment required
♦ Used oil collection and extraction unit -V.A.G 1782-
Removing
Proceed as follows:
Note
Observe general repair instructions
♦
Observe rules for cleanliness when working on the gearbox
♦
⇒ page 10 .
– Remove front left wheel.
– Release fasteners -1 ... 4- and remove centre noise insulation.
– Remove noise insulation (left-side) -arrows-.
94
Rep. Gr.39 - Final drive - differential
⇒ page 8 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.