Removing And Installing Selector Lever Display Illumination Bulb L101 - Audi TT 2007 Workshop Manual

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
Installing
Installation is carried out in reverse sequence; note the following:
Note
To install the selector lever handle, the interlock button must
♦
be pulled out as far as it will go and secured with either a cable
tie -arrow- or with the assembly aid supplied with the new han‐
dle.
If the interlock button was not secured, do not attempt to pull
♦
it out of the selector lever handle using mechanical tools. In‐
stead, apply a compressed air gun to the bottom of the handle,
blow out the interlock button and secure it in this position.
– Push selector lever handle fully onto selector lever.
• The interlock button faces the driver.
• The handle must engage in the annular groove on the selector
lever.
– Remove cable tie or assembly aid.
• The interlock button mechanism should engage in the vertical
groove on the selector lever. If not, press the interlock button
into the selector lever handle.
– Bring hose clip -1- into correct position.
• The lug -arrow- on the hose clip faces front right.
– Clamp selector lever handle -2- on selector lever by tightening
hose clip with hose clip pliers -V.A.G 1275- .
– Clip retainer frame -3- for selector lever boot onto trim for se‐
lector lever boot.
2.2 Removing and installing selector lever
display illumination bulb -L101-
Removing
Proceed as follows:
– Apply handbrake.
– Shift selector lever into position "N".
– Switch off ignition and take out ignition key.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
28
Rep. Gr.34 - Controls, housing