Servicing Selector Mechanism - Exploded View - Audi TT 2007 Workshop Manual

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
3

Servicing selector mechanism - exploded view

Note
Lubricate all bearings and moving surfaces with polycarbamide grease ⇒ Parts catalogue .
1 - Support bracket
❑ For selector lever cable
2 - Bolt
❑ 20 Nm + 90°
❑ 2 x
❑ Renew
3 - Retaining clip
❑ Renew
4 - Bolt
❑ 13 Nm
5 - Locking plate
❑ Renew
6 - Selector lever cable
❑ Do not bend or kink
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
❑ Renew selector lever
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
cable if sleeves are
damaged
❑ Adjusting ⇒ page 40
❑ Removing and installing
⇒ page 36
❑ Do not grease cable eye
7 - Nut
❑ 8 Nm
❑ Selector mechanism to
body
❑ 4 x
8 - Buffer stop for selector lever
❑ Clipped onto selector
mechanism
9 - Shift unit
❑ With integrated printed circuit for selector mechanism ( selector lever -E313- )
Caution
Electronic components
of selector mechanism
can be damaged by elec‐
trostatic discharge.
♦ Do not touch printed cir‐
cuit with bare hands.
❑ Incorporates tiptronic switch -F189- and selector lever lock solenoid -N110-
❑ tiptronic switch -F189- and selector lever lock solenoid -N110- can be checked via "Guided Fault Finding"
⇒ Vehicle diagnosis, testing and information system VAS 5051
❑ If tiptronic switch -F189- or selector lever lock solenoid -N110- are defective, renew shift unit
30
Rep. Gr.34 - Controls, housing