Removing And Installing Selector Lever Lock Solenoid N110; Checking Connectors On Selector Mechanism - Audi TT 2007 Workshop Manual

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
Note
The shift unit has to be renewed if the tiptronic switch -F189- is
defective ⇒ page 33 .
3.7 Removing and installing selector lever
lock solenoid -N110-
The selector lever lock solenoid -N110- is integrated in the shift
unit; it cannot be renewed separately.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Note
with respect to the correctness of information in this document. Copyright by AUDI AG.
The shift unit has to be renewed if the selector lever lock solenoid
-N110- is defective ⇒ page 33
3.8 Checking connectors on selector mech‐
anism
Proceed as follows if malfunctions occur in the selector mecha‐
nism:
– Connect vehicle diagnostic, testing and information system -
VAS 5051B- .
– "Interrogate fault memory - all fault menus", trace and elimi‐
nate any faults displayed via "Guided Fault Finding".
A - 10-pin connector for wiring from selector mechanism to gear‐
box (with CAN wires)
B - 4-pin connector for wiring to selector lever lock solenoid -
N110- and selector lever locked in position P switch -F319-
C - 10-pin connector for wiring to cover of selector mechanism
42
Rep. Gr.34 - Controls, housing
.