Removing And Installing Pendulum Support - Audi TT 2007 Workshop Manual

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
– Remove bolts -1- and detach gearbox mounting -A-.
Installing
• Tightening torques ⇒ page 59
Installation is carried out in reverse sequence; note the following:
– Secure gearbox mounting -A-.
Caution
Screw in bolts straight when fitting as otherwise the threads in
the support arm of the gearbox mounting will be damaged.
♦ Before fitting the bolts -arrows-, the gearbox support and
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
the support arm of the gearbox mounting must be aligned
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
absolutely parallel. If necessary, push the gearbox up at
the rear with a trolley jack.
– Pull gearbox up with spindle on support bracket until gearbox
support contacts support arm of gearbox mounting.
– Adjust assembly mountings ⇒ Rep. Gr. 10 .
– Secure support arm of gearbox mounting to gearbox support.
– Detach support bracket -10 - 222 A- from engine.
8.2 Removing and installing pendulum sup‐
port
Removing
Proceed as follows:
– Release fasteners -1 ... 4- and remove centre noise insulation.
– Unscrew bolts -1 ... 3- and remove pendulum support.
64
Rep. Gr.34 - Controls, housing