Adjusting Selector Lever Cable - Audi TT 2007 Workshop Manual

Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
Caution
Electronic components of selector mechanism can be dam‐
aged by electrostatic discharge.
♦ Do not touch printed circuit -B- with bare hands.
– Clip detent plate -A- into position on both sides.
– Tighten bolts -arrows-.
– Loosely attach cover for shift unit (with glued-on seal) to shift
unit -arrows-, making sure that seal is seated correctly.
– Fit sleeve for selector lever cable in cover for shift unit.
– Press selector lever cable onto selector shaft lever on gearbox
in opposite direction of -arrow-.
– Fit retaining clip -A- and press downwards to secure.
– Install locking plate -C-.
– Move selector lever from "S" to "P".
Note
Check that selector lever moves freely.
♦
If the selector mechanism is stiff, renew the selector lever ca‐
♦
ble or service the selector mechanism.
– Secure cover for shift unit -arrows-.
– Install heat shield ⇒ Rep. Gr. 66 .
– Install exhaust system so it is free of stress ⇒ Rep. Gr. 26 .
– Adjust selector lever cable
– Check selector mechanism
3.5

Adjusting selector lever cable

Procedure
Proceed as follows:
40
Rep. Gr.34 - Controls, housing
⇒ page 40 .
⇒ page 32 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.